Certified & Insured

Washer Repair Cordova Bay

A washer stuck mid-cycle, refusing to fill, or thumping against the wall doesn't usually mean it's finished. Most calls trace back to one identifiable part, found fast and fixed the same visit.

Front-load washing machine in a Cordova Bay laundry room
Types We Service

Washer Types We Repair

Whatever sits in your laundry room, we've likely serviced one just like it.

Front-Load

Door on the front, stacks with a dryer

Top-Load Agitator

Centre post, lid opens on top

Top-Load HE

No agitator, lid opens on top

Compact / Stackable

Narrow body, fits in a closet

What We Fix

Common Washer Problems, Explained

Tap a symptom below to see what's usually causing it.

Won't Spin At All

Drum fills and agitates normally, but the spin cycle never kicks in, leaving a soaked load. Usually a lid or door switch not registering as fully latched.

Leaking From The Base

A small pool forming underneath during the wash. On front-load machines this is almost always the rubber door boot, worn thin or split at one fold.

Won't Fill With Water

Tub sits empty no matter how many minutes tick by after pressing start. Usually the inlet valve has stuck closed, or a supply hose has kinked shut somewhere behind the machine.

Shaking The Whole Room

Feels like the machine is trying to walk across the floor mid-spin. Suspension springs or shocks wear out over the years and stop absorbing the movement.

Deep Banging Noise

A heavy thud on every rotation that's gradually gotten louder. This pattern almost always points to a drum bearing wearing down internally.

Stops Partway Through

Cycle halts mid-wash and throws an error on the display. Usually a water-level sensor sending the control board bad readings.

Still Not Sure What's Wrong?

Skip the guesswork, one visit usually gets it fixed the same day.

Brands We Service

Every technician has hands-on experience with each of these, not just a manual to follow.

Whirlpool KitchenAid Maytag GE Samsung LG Frigidaire Bosch Kenmore Electrolux
Testimonials

Washer Repairs, Straight From Cordova Bay

Straight from Cordova Bay laundry rooms, in the customers' own words.

Washer had started walking a good foot across the floor every time it hit spin, loud enough to hear from another room. Suspension components had worn unevenly, replaced as a set and it holds its ground now.

Oswin K.

A puddle appeared near the front of the machine after nearly every wash, small but persistent. Door boot seal had a split near the bottom, replaced and it's stayed dry since.

Bellamy R.

Clear, patient explanation of the drain issue before touching anything. Docked one star only because the part needed a couple extra days to arrive.

Cressida M.

Machine wouldn't take on a single drop of water no matter how long we let it run. Inlet valve had seized shut, cleared it and confirmed a proper fill before he left.

Thaddeus P.

That deep clunk on every spin had been bothering us for weeks before we called. Drum bearing had worn through, replaced and it's dead quiet now.

Ottoline V.

Cycle kept stopping halfway with an error code we didn't recognize. Water-level sensor was misreading, swapped and every load finishes properly now.

Percival D.

Service Areas

Serving Cordova Bay And Beyond

Same-day appointments across the neighbourhood and the surrounding communities.

  • Cordova Bay
  • Broadmead
  • Cadboro Bay
  • Ten Mile Point
  • Queenswood
  • Gordon Head
Book Now

Why Cordova Bay Chooses Us

  • $0 diagnostic fee with completed repair
  • Certified and insured technicians
  • 88% fixed on the first visit
(250) 702-2213

Book Your Repair

Send us your details and a technician will reach out to set a time.